Identify whether it is one light or many
We test whether the flicker is confined to one fitting or affects a whole circuit, which points to the likely source.
Electrical Problems
Flickering lights are often a wiring issue, not a bulb problem. Renovix traces the cause and fixes it at the circuit.
What This Problem Means
A clear, honest explanation of what is happening so you know what you are dealing with.
Flickering lights are lights that dim, pulse, or go on and off intermittently. They are easy to dismiss as a loose bulb, but persistent flickering usually points to a wiring or connection issue somewhere in the circuit. Flickering can affect one light or a whole group, and the pattern matters — a light that flickers in one room is different from lights that flicker when an appliance is switched on.
Common causes include a loose connection at the switch or light fitting, a poor connection in a joint, a circuit that is overloaded, or appliances that draw large surges when they start. For older homes, flickering can also be a sign of old, worn wiring or a failing breaker. Because the underlying cause can be electrical, it is worth having it checked rather than assuming the fitting is faulty.
The short answer
Flickering lights are often a wiring issue, not a bulb problem. Renovix traces the cause and fixes it at the circuit.
We explain the cause and the fix, not just the symptom.
Common Causes
Understanding the cause helps you know why it happened and what the right fix is.
A loose bulb or a poor contact in the lamp holder.
A loose connection at the switch or the light fitting.
An overloaded circuit where the voltage dips when appliances run.
A faulty dimmer switch or an incompatible bulb.
Worn or old wiring with a poor joint.
A failing breaker or a loose connection in the distribution board.
Warning Signs
Spotting these signs early can often prevent a small problem from becoming a larger repair.
A light flickers consistently, not just occasionally.
Lights dim when an appliance like the aircond or water heater starts.
Several lights flicker at the same time.
The flickering is accompanied by warmth, sparking or a smell.
Possible Solutions
The practical approaches we take to resolve this problem — from a targeted repair to a fuller solution.
We test whether the flicker is confined to one fitting or affects a whole circuit, which points to the likely source.
We inspect the lamp holder, bulb, switch and dimmer for a loose contact or an incompatible combination.
Loose connections in the joint, switch or board are secured so the current flows steadily.
If the circuit is overloaded or the wiring is old, we advise on rebalancing or upgrading the circuit.
When to Call a Professional
Some problems are worth handling early, and some should always be left to a professional. Here is when to get in touch.
A light flickers constantly and a new bulb does not fix it.
Lights across the house dim when an appliance runs.
Flickering is accompanied by heat, sparking or a burning smell.
The flicker is coming from the distribution board rather than the fitting.
Related Renovix Service
Flickering Lights is handled by our Electrical team. The related services below are often part of the same job.
Sub-Services
These are the scopes we carry out for this problem. Each one has its own page explaining the work, what is included and what changes the cost.
Under Electrical
Under Electrical
Under Electrical
Our Work
Real photographed jobs from our portfolio whose scope genuinely covers this kind of problem.
Our Process
Flickering is a symptom, and the fix is to find the connection or load causing it. This is how we work.
We check whether the flicker follows the fitting, the switch or the circuit.
We examine the lamp holder, switch, joints and board connections for looseness.
We tighten or replace the affected connection, fitting or component.
The lights are tested again to confirm the flicker is gone and the supply is steady.
Property Types
Flickering lights affect every property type, and are especially common in older homes and times of high appliance use.
Rewiring, trips, sockets, switches and lighting for landed homes with older circuits.
Larger electrical scopes and high-load circuits involving multiple appliances and outdoor lighting.
Fault repairs, sockets and switching within the unit, coordinated with management rules.
Practical electrical fixes for apartment points, lighting and the distribution board.
Circuit loads, power points, lighting and fault-finding for commercial spaces.
Rewiring and new points planned before plastering, ceilings and painting.
Service Areas
Electrical fault-finding and repairs are available across Kuala Lumpur, Selangor and the wider Klang Valley. Electrical installation work in Malaysia is subject to regulatory requirements — we can advise on what applies to your specific installation.
The federal capital — heritage shophouses, mid-century landed estates, older flats and a dense high-rise belt, all within one city.
Malaysia's most developed state — from 1950s Petaling Jaya and royal Klang to fast-growing corridors like Puchong, Kota Damansara and Cyberjaya.
Local housing stock, common problems and practical service notes for neighbourhoods and towns across the Klang Valley.
Not sure if we cover your area? Ask us — we serve most Klang Valley locations.
FAQs
Straight answers to the questions customers ask us most about this problem.
Occasional flicker can be harmless, but persistent flickering can indicate a loose connection or overloaded circuit that should be checked to avoid it worsening.
The aircond draws a large surge of current when it starts. If the circuit or supply is struggling, the lights dim briefly. If it is frequent, the circuit may need attention.
Sometimes. We would always swap the bulb first. If the flicker continues, it is worth checking the fitting, switch and wiring.
Yes. LEDs can flicker with an incompatible dimmer, or with a loose connection. We check compatibility when the flicker persists.
If a single light flickers from a loose bulb, it is usually minor. If lights dim across rooms, or flickering is accompanied by heat or a smell, it is time to call an electrician.
Knowledge Hub
Background reading on cost, materials and what the work involves.
Related Problems
These issues frequently appear together in Kuala Lumpur and Selangor homes.
A switch that sparks, flickers or feels warm is a wiring problem, not a worn-out part. Renovix replaces it safely and tests it.
View problemA short circuit is a genuine electrical fault. Renovix locates and repairs it safely — it is not a problem to keep resetting.
View problemWiring installed decades ago was never designed for today's loads. Renovix assesses old wiring and rewires homes safely.
View problemA breaker that trips repeatedly is protecting a circuit with a problem. Renovix finds the cause safely instead of just switching it back on.
View problemGet a Free Quote
Describe what you are seeing and where the property is located, and we will advise on the next step.
Call or WhatsApp: +601159259521